Listing Condition as Used even though Look and Operate Like New. LUTRON QSGR-6P-WH GRAFIK Eye QS 6-zone Control Unit with line voltage dimming. Serial Number 01E3 4BCA SM-Z46. GRAFIK Eye QS is the premier energy-saving light and shade control. The GRAFIK Eye QS control unit includes an astronomic time clock, intuitive lighting presets, and direct shade control. Additionally, theGRAFIK Eye QS control unit is compatible with all Lutron wired QS products and systems, includingQuantum systems. Fits into a 4-gang U. Backbox, 3` in (90.4 mm) deep (Lutron P/N 245-254) or3 in (76.2 mm) deep (Lutron P/N 241-400). Pushbutton recall of four preset lighting scenes, plus Off. Sixteen (16) total available scenes, plus Off scene. Zones can control many light source types directly. Or through power modules. Optional integrated shade control buttons, which. Can also be added to the unit after installation. Master override buttons to raise and lower all lights. Allows setup of lighting scenes and shade presets. Using buttons on the control unit. Built-in infrared (IR) receiver. Info screen shows zone light level percentage. Energy savings, zone labeling, and programming. Lockout option prevents accidental changes. Occupancy sensor input and 24 V- power for one. QS communication link for seamless integration of. Lights, motorized window treatments, occupancy. Sensors, wallstations, and integration interfaces. Compatible with all Lutron QS system components. Backlit buttons with engraving make unit easy to. Available in a variety of colors and finishes. 120127 V 50/60 Hz. 220240 V 50/60 Hz. CULus CEC (Title 24). 32 to 104 °F (0 to 40 °C). Relative humidity less than 90% non-condensing. Zones on Energi Savr Node products wired to the sameQS link. Zones on Energi Savr Node with Softswitch Zones on Energi Savr Node for 010 V Zones on Energi Savr Node with EcoSystemPlease refer to Remote Zone Mapping forimportant information. DMX channel(s) through DMX output interface(QSE-CI-DMX). Please refer to Accessory Controls: DMXOutput Interface. Controls the following lighting sources with a smooth, continuous square law dimming curve or on a fullconduction non-dim basis. Lutron Tu-Wire electronic fluorescent dimming ballast. Lutron Hi-lume 2-wire LTE LED driver. Advance Mark 10R electronic dimming ballast. Neon and cold cathode. Non-dim incandescent, magnetic low-voltage, Tu-Wire. Cree LR4/6, 120 V fixtures for loading capacities. Controls the following lighting sources with a smooth, continuous square law dimming curve or on a fullconduction non-dim basis through separate Lutron powerinterfaces. Electronic low-voltage transformers (use ELV orPhase-Adaptive power module: PHPM-PA-DV-WH/PHPM-PA-120-WH). Lutron 3-wire controlled electronic fluorescent dimmingballasts (use fluorescent 3-wire power module:PHPM-3F-DV-WH / PHPM-3F-120-WH). Lutron 3-wire controlled LED drivers (use flourescent3-wire power module: PHPM-3F-DV-WH/PHPM-3F-120-WH). Non-dim (use switching module: PHPM-SW-DV-WH). 010 V (use TVI). Note: A zone may be programmed to control only oneload type at a time. Lightning strike protection meets ANSI/IEEE standard62.41-1980. Can withstand voltage surges of up to6000 V and current surges of up to 3000 A. Tested to withstand 16 kV electrostatic discharge withoutdamage or memory loss. RTISS-equipped: Compensates in real time for incomingline voltage variations (no visible flicker with +/-2%change in RMS voltage per cycle, and +/-2% Hz changein frequency per second). Power failure memory retains programming and light levelsettings for up to 10 years in the event of a power loss. The GRAFIK Eye QS control unit supplies 3 Power DrawUnits (PDUs) on the QS link. Faceplate is hinged at the top and bottom, and staysopen at 180° for ease of access. Scene and Shade Buttons. Large, rounded buttons are easy to use. Backlit buttons with optional engraving make it easy to. Find and to operate the control unit in low light conditions. (backlight can be disabled). Optional button engraving is angled up to the eye for. Predefined label stickers are included for field labeling. 4 preset lighting scenes, plus Off, are accessible from the. Front of the control unit. 12 additional scenes are stored in the control unit and. Are accessible from the integral timeclock, seeTouch QS. Wallstations, and QS interfaces. Light levels fade smoothly between scenes. Can be set differently for each scene: 0 to 59 seconds, or1 to 60 minutes. Maximum fade time from Scene Off is 3 seconds. The item “LUTRON QSGR-6P GRAFIK Eye QS 6-zone Lighting Control System Unit Dimmer 4BCA” is in sale since Tuesday, April 13, 2021. This item is in the category “Business & Industrial\Facility Maintenance & Safety\Facility Lighting\Other Lights & Lighting”. The seller is “topav1997″ and is located in Indio, California. This item can be shipped worldwide.
- MPN: QSGR-6P
- Brand: Lutron
